To Next Page

To Previous Page

8-14

Time Protocols

TimeP: Viewing, Selecting, and Configuring

Table 8-2.Timep Parameters

Menu: Viewing and Configuring TimeP

To View, Enable, and Modify the TimeP Protocol:

1. From the Main Menu, select:

2. Switch Configuration...

1. System Information

SNTP Parameter Operation

Time Sync

Method

Used to select either TIMEP (the default), SNTP, or None as the time synchronization method.

Timep Mode

Disabled The Default. Timep does not operate, even if specified by the Menu interface Time Sync Method

parameter or the CLI timesync command.

DHCP When Timep is selected as the time synchronization method, the switch attempts to acquire a Timep

server IP address via DHCP. If the switch receives a server address, it polls the server for updates

according to the Timep poll interval. If the switch does not receive a Timep server IP address, it cannot

perform time synchronization updates.

Manual When Timep is selected as the time synchronization method, the switch attempts to poll the specified

server for updates according to the Timep poll interval. If the switch fails to receive updates from the

server, time synchronization updates do not occur.

Server

Address

Used only when the TimeP Mode is set to Manual. Specifies the IP address of the TimeP server that

the switch accesses for time synchronization updates. You can configure one server.

Poll Interval

(minutes)

Default: 720 minutes. Specifies the interval the switch waits between attempts to poll the TimeP server

for updates.

!Software.book Page 14 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General