To Next Page

To Previous Page

11-44

Port-Based Virtual LANs (VLANs) and GVRP

GVRP

Enabling and Disabling GVRP on the Switch. This command enables

GVRP on the switch.

Syntax: gvrp

This example enables GVRP:

HPswitch(config)# gvrp

This example disables GVRP operation on the switch:

HPswitch(config)# no gvrp

Enabling and Disabling GVRP On Individual Ports. When GVRP is

enabled on the switch, use the unknown-vlans command to change the

Unknown VLAN field for one or more ports. You can use this command at

either the Manager level or the interface context level for the desired port(s).

Syntax: interface <port-list> unknown-vlans Changes the Unknown VLAN

<learn | block | disable> field setting for the specified

port(s).

For example, to change and view the configuration for ports A1-A2 to Block:

Figure 11-31. Example of Preventing Specific Ports from Joining Dynamic VLANs

!Software.book Page 44 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General