To Next Page

To Previous Page

13-19

802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)

802.1p Spanning-Tree Protocol (STP)

Menu: Configuring 802.1D STP

1. From the Main Menu, select:

2. Switch Configuration . . .

4. Spanning Tree Operation

Figure 13-5. The Default “Spanning Tree Operation” Screen

2. Press (for

Edit) to highlight the Protocol Version field. In the default

configuration this field is set to RSTP.

3. Press the Space bar once to change the field to STP. This changes the

Protocol Version selection to the 802.1d Spanning Tree Protocol.

4. Press [v] to highlight the STP Enabled field.

5. Press the Space bar to select Yes. (Yes in this field means to enable

spanning-tree operation.)

Use this field to select the 802.1d version of STP.

!Software.book Page 19 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General