HP ProCurve 2650

8-16
Time Protocols
TimeP: Viewing, Selecting, and Configuring
Note: This step replaces any previously configured TimeP server
IP address.
iii. Press [>] to move the cursor to the
Poll Interval field, then go to
step 6.
6. In the
Poll Interval field, enter the time in minutes that you want for a TimeP
Poll Interval.
Press to return to the Actions line, then (for
Save) to enter the new
time protocol configuration in both the startup-config and running-config
files.
CLI: Viewing and Configuring TimeP
CLI Commands Described in this Section
This section describes how to use the CLI to view, enable, and configure TimeP
parameters.
Viewing the Current TimeP Configuration
This command lists both the time synchronization method (TimeP, SNTP, or
None) and the TimeP configuration, even if SNTP is not the selected time
protocol.
Syntax: show timep
show timep page 8-16
[no] timesync page 8-17 ff., 8-19
ip timep
dhcp page 8-17
manual page 8-18
server <ip-addr> page 8-18
interval page 8-19
no ip timep page 8-20
!Software.book Page 16 Thursday, October 10, 2002 6:10 PM