To Next Page

To Previous Page

C-30

Troubleshooting

Diagnostic Tools

Displaying the Configuration File

The complete switch configuration is contained in a file that you can browse

from either the CLI or the web browser interface. It may be useful in some

troubleshooting scenarios to view the switch configuration.

CLI: Viewing the Configuration File

Using the CLI, you can display either the running configuration or the startup

configuration. (For more on these topics, see chapter 5, “Switch Memory and

Configuration”.)

Syntax: write terminal Displays the running-config file.

show running-config Displays the running-config file.

show config Displays the startup-config file.

Web: Viewing the Configuration File

To display the running configuration, through the web browser interface:

1. Click on the

Diagnostics tab.

2. Click on

3. Use the right-side scroll bar to scroll through the configuration listing.

Listing Switch Configuration and Operation Details

The show tech command outputs, in a single listing, switch operating and

running configuration details from several internal switch sources, including:

■ Image stamp (software version data)

■ Running configuration

■ Event Log listing

■ Boot History

■ Port settings

■ Status and counters — port status

■ IP routes

■ Status and counters — VLAN information

■ GVRP support

■ Load balancing (trunk and LACP)

■ Stacking status — this switch and all

Syntax:show tech

!Software.book Page 30 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General