To Next Page

To Previous Page

4-8

Using the HP Web Browser Interface

Tasks for Your First HP Web Browser Interface Session

This window is the launching point for the basic configuration you need to

perform to set web browser interface passwords to maintain security and

Fault Detection policy, which determines the types of messages that will be

displayed in the Alert Log.

To set web browser interface passwords, click on secure access to the device

to display the Device Passwords screen, and then go to the next page. (You

can also access the password screen by clicking on the Security tab.)

To set Fault Detection policy, click on select the fault detection configuration in

the second bullet in the window and go to the section, “Setting Fault Detection

Policy” on page 4-23. (You can also access the password screen by clicking on

the Configuration tab, and then button.)

Creating Usernames and Passwords in the Browser

Interface

You may want to create both a username and password to create access

security for your switch. There are two levels of access to the interface that

can be controlled by setting user names and passwords:

■ Operator. An Operator-level user name and password allows read-only

access to most of the web browser interface, but prevents access to the

Security window.

■ Manager. A Manager-level user name and password allows full read/

write access to the web browser interface.

!Software.book Page 8 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General