To Next Page

To Previous Page

14-45

HP Procurve Stack Management

Configuring Stack Management

■ Stacking uses only the primary VLAN on each switch in a stack.

■ The primary VLAN can be tagged or untagged as needed in the

stacking path from switch to switch.

■ The same VLAN ID (VID) must be assigned to the primary VLAN in

each stacked switch.

Web: Viewing and Configuring Stacking

Figure 14-38. Example of the Web Browser Interface for a Commander

The web browser interface for a Commander appears as shown above. The

interface for Members and Candidates appears the same as for a non-stacking

Switches 2650 and 6108.

To view or configure stacking on the web browser interface:

1. Click on the Configuration tab.

2. Click on to display the stacking configuration for an individual

switch, and make any configuration changes you want for that switch.

3. Click on to save any configuration changes for the individual

switch.

4. If the switch is a Commander, use the and

buttons for viewing and using stack features.

To access the web-based Help provided for the switch, click on in the web

browser screen.

!Software.book Page 45 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General