HP ProCurve 2650

8-13
Time Protocols
TimeP: Viewing, Selecting, and Configuring
Disabling the SNTP Mode. If you want to prevent SNTP from being used
even if selected by
timesync (or the Menu interface’s Time Sync Method param-
eter), configure the SNTP mode as disabled.
Syntax: no sntp Disables SNTP by changing the SNTP mode
configuration to Disabled.
For example, if the switch is running SNTP in Unicast mode with an SNTP
server at 10.28.227.141 and a server version of 3 (the default),
no sntp changes
the SNTP configuration as shown below, and disables time synchronization
on the switch.
Figure 8-8. Example of Disabling Time Synchronization by Disabling the SNTP Mode
TimeP: Viewing, Selecting, and
Configuring
Even though the Time Sync Mode is set to Sntp,
time synchronization is disabled because no
sntp has disabled the SNTP Mode parameter.
TimeP Feature Default Menu CLI Web
view the Timep time synchronization configuration n/a page 8-14 page 8-16 —
select Timep as the time synchronization method TIMEP page 8-13 pages 8-17
ff.
—
disable time synchronization timep page 8-15 page 8-19 —
enable the Timep mode Disabled —
DHCP — page 8-15 page 8-17 —
manual — page 8-15 page 8-18 —
none/disabled — page 8-15 page 8-20 —
change the SNTP poll interval 720 minutes page 8-16 page 8-19 —
!Software.book Page 13 Thursday, October 10, 2002 6:10 PM