To Next Page

To Previous Page

4-2

Using the HP Web Browser Interface

Overview

The HP web browser interface built into the switch lets you easily access the

switch from a browser-based PC on your network. This lets you do the

following:

■ Optimize your network uptime by using the Alert Log and other diagnostic

tools

■ Make configuration changes to the switch

■ Maintain security by configuring usernames and passwords

This chapter covers the following:

■ General features (page 4-3).

■ Starting a web browser interface session (page 4-4)

■ Tasks for your first web browser interface session (page 4-7):

• Creating usernames and passwords in the web browser interface

(page 4-8)

• Selecting the fault detection configuration for the Alert Log operation

(page 4-23)

• Getting access to online help for the web browser interface (page

4-11)

■ Description of the web browser interface:

• Overview window and tabs (page 4-15)

• Port Utilization and Status displays (page 4-16)

• Alert Log and Alert types (page 4-19)

• Setting the Fault Detection Policy (page 4-23)

Note If you want security beyond that achieved with user names and passwords,

you can disable access to the web browser interface. This is done by either

executing no web-management at the Command Prompt or changing the Web

Agent Enabled parameter setting to No (page 6-4).

!Software.book Page 2 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General