EasyManuals Logo

HP ProCurve 2650 User Manual

HP ProCurve 2650
524 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #388 background imageLoading...
Page #388 background image
14-40
HP Procurve Stack Management
Configuring Stack Management
Syntax: no stack name <stack name>
stack join <mac-address>
If you dont know the MAC address of the destination Commander, you can
use
show stack all to identify it.
For example, suppose you have a Switch 2650 or Switch 6108 operating as the
Commander for a temporary stack named Test. When it is time to eliminate
the temporary Test stack and convert the Switch 2650 or Switch 6108 into a
member of an existing stack named Big_Waters, you would execute the
following commands in the CLI of the Switch 2650 or 6108:
Figure 14-33. Example of Command Sequence for Converting a Commander to a Member
Using the CLI To Remove a Member from a Stack
You can remove a Member from a stack using the CLI of either the Commander
or the Member.
Note When you remove a Member from a stack, the Members Auto Join parameter
is set to
No.
Using the Commander CLI To Remove a Stack Member. This option
requires the switch number (SN) and the MAC address of the switch to
remove. (Because the Commander propagates its Manager password to all
stack members, knowing the Manager password is necessary only for gaining
access to the Commander.)
Eliminates the Test stack and converts
the Commander to a Candidate.
Helps you to identify the MAC address of the
Commander for the Big_Waters stack.
Adds the former Test Commander to the
Big_Waters stack.
!Software.book Page 40 Thursday, October 10, 2002 6:10 PM

Table of Contents

Other manuals for HP ProCurve 2650

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

HP ProCurve 2650 Specifications

General IconGeneral
Switching Capacity13.6 Gbps
Forwarding Rate10.1 Mpps
Layer2
Jumbo Frame SupportYes
Form FactorRack-mountable
VLAN SupportYes
Layer 3 RoutingNo
PoE SupportNo
FanlessNo
AltitudeUp to 3, 000 meters
ManagementCLI, SNMP
Operating Temperature0°C to 50°C
Storage Temperature-40°C to 70°C
Humidity15% to 95% non-condensing

Related product manuals