A-13
File Transfers
Transferring Switch Configurations
■ For a Unix TFTP server, the file permissions for the switch software file
do not allow the file to be copied.
■ Another console session (through either a direct connection to a terminal
device or through Telnet) was already running when you started the
session in which the download was attempted.
Note If an error occurs in which normal switch operation cannot be restored, the
switch automatically reboots itself. In this case, an appropriate message is
displayed after the switch reboots.
Transferring Switch Configurations
Transfer Features
Using the CLI commands described in this section, you can copy switch
configurations to and from a switch.
TFTP: Copying a Configuration from a Remote Host.
Syntax: copy tftp <startup-config | running-config> <ip-address> <remote-file>
This command copies a configuration from a remote host to the startup-config
file in the switch. (See Chapter 5, “Using Primary and Secondary Flash Image
Options” for information on the startup-config file.)
For example, to download a configuration file named HPswitch in the configs
directory on drive “d” in a remote host having an IP address of 10.28.227.105:
HPswitch# copy tftp startup-config 10.28.227.105
d:\configs\HPswitch
Feature Default Menu CLI Web
use TFTP to copy from a remote
host to a config file
n/a — below —
use TFTP to copy a config file to a
remote host
n/a — page A-14 —
use Xmodem to copy a
configuration from a serially
connected host to a config file
n/a — page A-14 —
Use Xmodem to copy a config file
to a serially connected host
n/a — page A-15 —
!Software.book Page 13 Thursday, October 10, 2002 6:10 PM
To Next Page
Loading...
Need help?
General
