To Next Page

To Previous Page

B-24

Monitoring and Analyzing Switch Operation

Port and Static Trunk Monitoring Features

Menu: Configuring Port and Static Trunk Monitoring

This procedure describes configuring the switch for monitoring when moni-

toring is disabled. (If monitoring has already been enabled, the screens will

appear differently than shown in this procedure.)

1. From the Console Main Menu, Select:

2. Switch Configuration...

3. Network Monitoring Port

Figure B-18. The Default Network Monitoring Configuration Screen

2. In the Actions menu, press (for Edit).

3. If monitoring is currently disabled (the default) then enable it by pressing

the Space bar (or ) to select Yes.

4. Press the down arrow key to display a screen similar to the following and

move the cursor to the Monitoring Port parameter.

Enable monitoring

by setting this

parameter to “Yes”.

!Software.book Page 24 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General