EasyManuals Logo

HP ProCurve 2650 User Manual

HP ProCurve 2650
524 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #419 background imageLoading...
Page #419 background image
A-3
File Transfers
Downloading Switch Software
After an switch software download, you must reboot the switch to imple-
ment the newly downloaded code. Until a reboot occurs, the switch
continues to run on the software it was using before the download started.
Note Downloading new switch software does not change the current switch con-
figuration. The switch configuration is contained in separate files that can also
be transferred. See Transferring Switch Configurations on page A-13.
In most cases, if a power failure or other cause interrupts a flash image
download, the switch reboots with the image previously stored in primary
flash. In the unlikely event that the primary image is corrupted (which may
occur if a download is interrupted by a power failure), the switch goes into
boot ROM mode. In this case, use the boot ROM console to download a new
switch software image to primary flash. See Restoring a Flash Image on page
C-34.
Using TFTP To Download Switch Software from a
Server
This procedure assumes that:
An switch software file for the switch has been stored on a TFTP server
accessible to the switch. (The switch software file is typically available
from the HP Procurve website at http://www.hp.com/go/hpprocurve.)
The switch is properly connected to your network and has already been
configured with a compatible IP address and subnet mask.
The TFTP server is accessible to the switch through IP.
Before you use the procedure, do the following:
Obtain the IP address of the TFTP server in which the switch software file
has been stored.
If VLANs are configured on the switch, determine the name of the VLAN
in which the TFTP server is operating.
Determine the name of the switch software file stored in the TFTP server
for the switch (for example, G0101.swi).
Note If your TFTP server is a Unix workstation, ensure that the case (upper or
lower) that you specify for the filename is the same case as the characters
in the switch software filenames on the server.
!Software.book Page 3 Thursday, October 10, 2002 6:10 PM

Table of Contents

Other manuals for HP ProCurve 2650

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

HP ProCurve 2650 Specifications

General IconGeneral
Switching Capacity13.6 Gbps
Forwarding Rate10.1 Mpps
Layer2
Jumbo Frame SupportYes
Form FactorRack-mountable
VLAN SupportYes
Layer 3 RoutingNo
PoE SupportNo
FanlessNo
AltitudeUp to 3, 000 meters
ManagementCLI, SNMP
Operating Temperature0°C to 50°C
Storage Temperature-40°C to 70°C
Humidity15% to 95% non-condensing

Related product manuals