To Next Page

To Previous Page

7-2

Configuring IP Addressing

Overview

You can configure IP addressing through all of the switch’s interfaces. You can

also easily edit a switch configuration file to allow downloading the file to

multiple Switches 2650 and 6108 without overwriting each switch’s unique

gateway and VLAN 1 IP addressing.

Why Configure IP Addressing? In its factory default configuration, the

switch operates as a multiport learning bridge with network connectivity

provided by the ports on the switch. However, to enable specific management

access and control through your network, you will need IP addressing. Table

7-1 on page 7-10 shows the switch features that depend on IP addressing to

operate.

!Software.book Page 2 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General