To Next Page

To Previous Page

4-4

Using the HP Web Browser Interface

Starting an HP Web Browser Interface Session with the Switch

Starting an HP Web Browser Interface

Session with the Switch

You can start a web browser session in the following ways:

■ Using a standalone web browser on a network connection from a PC or

UNIX workstation:

• Directly connected to your network

• Connected through remote access to your network

■ Using a management station running HP TopTools for Hubs & Switches

on your network

Using a Standalone Web Browser in a PC or UNIX

Workstation

This procedure assumes that you have a supported web browser installed on

your PC or workstation, and that an IP address has been configured on the

switch. (For more on assigning an IP address, refer to “IP Configuration” on

page 7-3.)

1. Make sure the Java

applets are enabled for your browser. If they are

not, use the options menu in your browser to do the following:

• In Netscape, enable the Java and JavaScript options.

• In Microsoft Internet Explorer, enable the Java Permissions.

Refer to your selected browser’s online Help for specific information on

enabling the Java applets.

Note: The authorized IP managers list can be used to limit access to the Web

interface to only select IP addresses. For more on this feature see the Access

Security Guide chapter "Using Authorized IP Managers"

!Software.book Page 4 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General