14-13
HP Procurve Stack Management
Configuring Stack Management
Menu: View Stack Status and Configure Stacking
Using the Menu Interface To View and Configure a
Commander Switch
1. Configure an IP address and subnet mask on the Commander switch.
(See Chapter 7, “Configuring IP Addressing”.)
2. Display the Stacking Menu by selecting Stacking in the Main Menu.
Figure 14-5. The Default Stacking Menu
3. Display the Stack Configuration menu by pressing to select
Stack
Configuration
.
Figure 14-6. The Default Stack Configuration Screen
!Software.book Page 13 Thursday, October 10, 2002 6:10 PM
To Next Page
Loading...
