To Next Page

To Previous Page

A-18

File Transfers

Copying Diagnostic Data to a Remote Host, PC, or Unix Workstation

Copying Crash Log Data Content to a Destination Device

This command uses TFTP or Xmodem to copy the Crash Log content to a PC

or UNIX workstation on the network. You can copy individual slot information

or the master switch information. If you do not specify either, the command

defaults to the master data.

Syntax: copy crash-log [<slot-id | master>] tftp <ip-address>

copy crash-log [<slot-id | master>] xmodem

where: slot-id = a - h, and retrieves the crash log or crash data from

the processor on the module in the specified slot.

master Retrieves crash log or crash data from the switch’s

chassis processor.

For example, to copy the Crash Log for slot C to a file in a PC connected to

the switch:

Figure A-11. Example of sending a Crash Log for Slot C to a File on an Attached PC

At this point, press

and start the

Xmodem command

sequence in your

terminal emulator.

!Software.book Page 18 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General