To Next Page

To Previous Page

12-10

Multimedia Traffic Control with IP Multicast (IGMP)

Web: Enabling or Disabling IGMP

HPswitch(vlan 1)# no ip igmp Returns IGMP traffic to

high-priority-forward “normal” priority.

HPswitch> show ip igmp config Show command to display

results of above high-priority

commands.

Configuring the Querier Function. The default querier capability is

“enabled”. This command disables or re-enables the ability for the switch to

become querier if necessary.

Syntax: [no] vlan <vid> ip igmp querier

Default: Yes

HPswitch(config)# no vlan 1 ip Disables the querier function

igmp querier on VLAN 1.

HPswitch> show ip igmp config Show command to display

results of above querier

command.

Web: Enabling or Disabling IGMP

In the web browser interface you can enable or disable IGMP on a per-VLAN

basis. To configure other IGMP features, telnet to the switch console and use

the CLI.

To Enable or Disable IGMP

1. Click on the Configuration tab.

2. Click on .

3. If more than one VLAN is configured, use the VLAN pull-down menu to

select the VLAN on which you want to enable or disable IGMP.

4. Use the Multicast Filtering (IGMP) menu to enable or disable IGMP.

5. Click on to implement the configuration change.

For web-based help on how to use the web browser interface screen, click on

the button provided on the web browser screen.

!Software.book Page 10 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General