EasyManuals Logo

HP ProCurve 2650 User Manual

HP ProCurve 2650
524 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #408 background imageLoading...
Page #408 background image
15-14
IP Routing Features
Configuring Static IP Routes
Static IP Route Parameters
When you configure a static IP route, you must specify the following param-
eters:
The IP address and network mask for the routes destination network.
The routes path, which can be one of the following:
The IP address of a next-hop gateway
A null interface. The routing switch drops traffic forwarded to the
null interface.
You also can specify the following optional parameters:
The routes metric The value the routing switch uses when comparing
this route to other routes in the IP route table to the same destination. The
metric applies only to routes that the routing switch has already placed
in the IP route table. The default metric for static IP routes is 1.
The routes administrative distance The value that the routing switch
uses to compare this route with routes from other route sources to the
same destination before placing a route in the IP route table. This param-
eter does not apply to routes that are already in the IP route table. The
default administrative distance for static IP routes is 1.
The default metric and administrative distance values ensure that the routing
switch always prefers static IP routes over routes from other sources to the
same destination.
Static Route States Follow Port States
IP static routes remain in the IP route table only so long as the next-hop
gateway, port, or virtual interface used by the route is available. If the gateway
or port becomes unavailable, the software removes the static route from the
IP route table. If the gateway or port later becomes available again, the
software adds the route back to the route table.
This feature allows the routing switch to adjust to changes in network
topology. The routing switch does not continue trying to use routes on
unavailable paths but instead uses routes only when their paths are available.
The following command configures a static route to 207.95.7.0, using
207.95.6.157 as the next-hop gateway.
HPswitch(config)# ip route 207.95.7.0/24 207.95.6.157
!Software.book Page 14 Thursday, October 10, 2002 6:10 PM

Table of Contents

Other manuals for HP ProCurve 2650

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

HP ProCurve 2650 Specifications

General IconGeneral
Switching Capacity13.6 Gbps
Forwarding Rate10.1 Mpps
Layer2
Jumbo Frame SupportYes
Form FactorRack-mountable
VLAN SupportYes
Layer 3 RoutingNo
PoE SupportNo
FanlessNo
AltitudeUp to 3, 000 meters
ManagementCLI, SNMP
Operating Temperature0°C to 50°C
Storage Temperature-40°C to 70°C
Humidity15% to 95% non-condensing

Related product manuals