To Next Page

To Previous Page

11-38

Port-Based Virtual LANs (VLANs) and GVRP

GVRP

Per-Port Options for Dynamic VLAN Advertising and

Joining

Initiating Advertisements. As described in the preceding section, to

enable dynamic joins, GVRP must be enabled and a port must be configured

to Learn (the default). However, to send advertisements in your network, one

or more static (Tagged, Untagged, or Auto) VLANs must be configured on one

or more switches (with GVRP enabled), depending on your topology.

Enabling a Port for Dynamic Joins. You can configure a port to dynami-

cally join a static VLAN. The join will then occur if that port subsequently

receives an advertisement for the static VLAN. (This is done by using the Auto

and Learn options described in table 11-11-4, below.

Parameters for Controlling VLAN Propagation Behavior. You can con-

figure an individual port to actively or passively participate in dynamic VLAN

propagation or to ignore dynamic VLAN (GVRP) operation. These options are

controlled by the GVRP “Unknown VLAN” and the static VLAN configuration

parameters, as described in the following table:

!Software.book Page 38 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General