14-3
HP Procurve Stack Management
Operation
Operation
Stacking Features
HP Procurve Stack Management (termed stacking) enables you to use a single
IP address and standard network cabling to manage a group of up to 16 total
switches in the same IP subnet (broadcast domain). Using stacking, you can:
■ Reduce the number of IP addresses needed in your network.
Feature Default Menu CLI Web
view stack status
view status of a single switch n/a page 14-26
thru
page 14-28
page 14-31 page 14-45
view candidate status n/a page 14-31
view status of commander and its
stack
n/a page 14-32
view status of all stacking-enabled
switches in the ip subnet
n/a page 14-32
configure stacking
enable/disable candidate Auto-Join enabled/Yes page 14-15 page 14-37
“push” a candidate into a stack n/a page 14-15 page 14-37
configure a switch to be a commander n/a page 14-13 page 14-33
“push” a member into another stack n/a page 14-24 page 14-39
remove a member from a stack n/a page 14-21 page 14-40
or
page 14-41
“pull” a candidate into a stack n/a page 14-17 page 14-36
“pull” a member from another stack n/a page 14-19 page 14-38
convert a commander or member to a
member of another stack
n/a page 14-24 page 14-39
access member switches for
configuration and traffic monitoring
n/a page 14-23 page 14-42
disable stacking enabled page 14-15 page 14-44
transmission interval 60 seconds page 14-13 page 14-44
!Software.book Page 3 Thursday, October 10, 2002 6:10 PM
To Next Page
Loading...
