To Next Page

To Previous Page

9-9

Optimizing Traffic Flow with Port Controls, Port Trunking, and Port-Based Priority

Viewing Port Status and Configuring Port Parameters

Configuring a Broadcast Limit on the Switch. Executing this command

configures the broadcast limit for all ports on the switch.

Syntax: broadcast-limit < 0 . . 99 >

For example, to configure a broadcast limit of 20% for all ports on the switch:

HPswitch(config)# broadcast-limit 20

To display the current broadcast limit setting, use one of the following com-

mands:

HPswitch# show config Displays the startup-config file. The

broadcast limit setting appears here

if configured and saved to the

startup-config file.

HPswitch# show running-config Displays the running-config file.

Web: Viewing Port Status and Configuring Port

Parameters

In the web browser interface:

1. Click on the Configuration tab.

2. Click on .

3. Select the ports you want to modify and click on .

4. After you make the desired changes, click on .

Note that the web browser interface displays an existing port trunk group.

However, to configure a port trunk group, you must use the CLI or the menu

interface. For more on this topic, see “Port Trunking” on page 9-10.

!Software.book Page 9 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General