9-8
Optimizing Traffic Flow with Port Controls, Port Trunking, and Port-Based Priority
Viewing Port Status and Configuring Port Parameters
Using the CLI To Configure Ports. You can configure one or more of the
following port parameters. For details on each option, see Table 9-9-1 on page
9-3.
Syntax: [no] interface <[ethernet] port-list>
disable | enable
speed-duplex
<auto-10 |10-full |
10-half |
100-full | 100-
half |
auto|1000-full
|>
flow-control
Note that in the above syntax you can substitute an “int” for “interface” and an
“e” for “ethernet”; that is int e <port-list>.
For example, to configure ports C1 through C3 and port C6 for 100Mbps full-
duplex, you would enter these commands:
HPswitch(config)# int e c1-c3,c6 speed-duplex 100-full
Similarly, to configure a single port with the settings in the above command,
you could either enter the same command with only the one port identified,
or go to the context level for that port and then enter the command. For
example, to enter the context level for port C6 and then configure that port
for 100FDx:
HPswitch(config)# int e c6
HPswitch(eth-C6)# speed-duplex 100-full
If port C8 was disabled, and you wanted to enable it and configure it for
100FDx with flow-control active, you could do so with either of the following
command sets.
■ These commands enable and configure port C8 from the config level:
HPswitch(config)# int e c8 enable
HPswitch(config)# int e c8 speed-duplex 100-full
HPswitch(config)# int e c8 flow-control
■ These commands select the context level for port C8 and then apply all
of the configuration commands to port C8:
HPswitch(config)# int e c8
HPswitch(eth-C8)# enable
HPswitch(eth-C8)# speed-duplex 100-full
HPswitch(eth-C8)# flow-control
!Software.book Page 8 Thursday, October 10, 2002 6:10 PM
To Next Page
Loading...
Need help?
General
