To Next Page

To Previous Page

3-8

Using the Command Line Interface (CLI)

Using the CLI

for VLAN 1 and later use the CLI to configure a different IP address of “Y” for

VLAN 1, then “Y” replaces “X” as the IP address for VLAN 1 in the running-

config file. If you subsequently execute write memory in the CLI, then the

switch also stores “Y” as the IP address for VLAN 1 in the startup-config file.

(For more on the startup-config and running config files, see Chapter 5,

“Switch Memory and Configuration”.)

Listing Commands and Command Options

At any privilege level you can:

■ List all of the commands available at that level

■ List the options for a specific command

Listing Commands Available at Any Privilege Level

At a given privilege level you can list and execute the commands that level

offers, plus all of the commands available at preceding levels. For example,

at the Operator level, you can list and execute only the Operator level

commands. However, at the Manager level, you can list and execute the

commands available at both the Operator and Manager levels.

Type "?" To List Available Commands. 1.Typing the

? symbol lists the

commands you can execute at the current privilege level. For example,

typing? at the Operator level produces this listing:

Figure 3-3. Example of the Operator Level Command Listing

!Software.book Page 8 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General