To Next Page

To Previous Page

13-22

802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)

802.1p Spanning-Tree Protocol (STP)

CLI: Configuring 802.1D STP

STP Commands Used in This Section

Viewing the Current STP Configuration. Regardless of whether STP is

disabled (the default), this command lists the switch’s full STP configuration,

including general settings and port settings.

Syntax: show spanning-tree config

When the switch is configured for 802.1d STP, this command displays infor-

mation similar to the following:

Figure 13-9. Example of the Default STP Configuration Listing with 802.1d STP

Configured at the Protocol Version

show spanning-tree config Below

spanning-tree

protocol-version page 13-23

forward-delay <4 - 30> page 13-24

hello-time <1 - 10> page 13-24

maximum-age <6 - 40> page 13-24

priority <0 - 65535> page 13-24

ethernet <port-list> page 13-25

path-cost <1 - 65535> page 13-25

priority <0 - 255> page 13-25

mode <norm | fast> page 13-25

show spanning tree Lists additional STP data not covered in this chapter. See

“Spanning Tree Protocol (STP) Information” on page B-17

Command Listing when

STP is the Protocol Version

(See also page 13-10

!Software.book Page 22 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General