To Next Page

To Previous Page

13-20

802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)

802.1p Spanning-Tree Protocol (STP)

Figure 13-6. Enabling Spanning-Tree Operation

6. If the remaining STP parameter settings are adequate for your network,

go to step 10.

7. Use or the arrow keys to select the next parameter you want to change,

then type in the new value or press the Space Bar to select a value. (If you

need information on STP parameters, press to select the Actions line,

then press

H to get help.)

8. Repeat step 7 for each additional parameter you want to change.

Note: For information on the Mode parameter, see “STP Fast Mode” on

page 13-26.

9. When you are finished editing parameters, press to return to the

Actions line.

10. Press to save the currently displayed STP parameter settings. You will

then see the “Switch Configuration Menu” with an asterisk (

*) at the

Spanning Tree Operation line, indicating that you must reboot the switch

before the Protocol Version change (step 5) takes effect.

Use this field to enable spanning tree.

Read-Only Fields

!Software.book Page 20 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General