13-18
802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)
Configuring Rapid Reconfiguration Spanning Tree (RSTP)
Web: Enabling or Disabling RSTP
In the web browser interface, you can enable or disable spanning tree on the
switch. If the default configuration is in effect such that RSTP is the selected
protocol version, enabling spanning tree through the web browser interface
will enable RSTP with its current configuration. To configure the other span-
ning tree features, telnet to the switch console and use the CLI or menu.
To enable or disable spanning tree using the web browser interface:
1. Click on the Configuration tab.
2. Click on .
3. Enable or disable spanning tree.
4. Click on to implement the configuration change.
!Software.book Page 18 Thursday, October 10, 2002 6:10 PM
To Next Page
Loading...
