To Next Page

To Previous Page

11-43

Port-Based Virtual LANs (VLANs) and GVRP

GVRP

3. Use the arrow keys to select the port you want, and the Space bar to select

Unknown VLAN option for any ports you want to change.

4. When you finish making configuration changes, press , then (for

ave) to save your changes to the Startup-Config file.

CLI: Viewing and Configuring GVRP

GVRP Commands Used in This Section

Displaying the Switch’s Current GVRP Configuration. This command

shows whether GVRP is disabled, along with the current settings for the

maximum number of VLANs and the current Primary VLAN. (For more on the

last two parameters, see “Port-Based Virtual LANs (Static VLANs)” on page

11-3.)

Syntax: show gvrp Shows the current settings.

Figure 11-29. Example of “Show GVRP” Listing with GVRP Disabled

Figure 11-30. Example of Show GVRP Listing with GVRP Enabled

show gvrp below

gvrp page 11-44

unknown-vlans page 11-44

This example includes

non-default settings for

the Unknown VLAN field

for some ports.

!Software.book Page 43 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General