To Next Page

To Previous Page

6-7

Interface Access, System Information, and Friendly Port Names

Interface Access: Console/Serial Link, Web, and Inbound Telnet

■ VT100 operation

■ 19,200 baud

■ No flow control

■ 10-minute inactivity time

■ Critical log events

you would use the following command sequence:

Figure 6-3. Example of Executing the Console Command with Multiple Parameters

You can also execute a series of console commands and then save the

configuration and boot the switch. For example:

Figure 6-4. Example of Executing a Series of Console Commands

The switch implements the Event Log change immediately. The switch implements

the other console changes after executing

write memory and reload.

Configure

the

individual

parameters.

Save the

changes.

Boot the

switch.

!Software.book Page 7 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General