To Next Page

To Previous Page

7-6

Configuring IP Addressing

IP Configuration

Figure 5-1. Example of the IP Service Configuration Screen without Multiple

VLANs Configured

2. Press (for Edit).

3. If the switch needs to access a router, for example, to reach off-subnet

destinations, select the Default Gateway field and enter the IP address of

the gateway router.

4. If you need to change the packet Time-To-Live (TTL) setting, select Default

TTL and type in a value between 2 and 255 (seconds).

5. To configure IP addressing, select IP Config and do one of the following:

• If you want to have the switch retrieve its IP configuration from a

DHCP or Bootp server, at the IP Config field, keep the value as DHCP/

Bootp and go to step 8.

• If you want to manually configure the IP information, use the Space

bar to select Manual and use the key to move to the other IP

configuration fields.

6. Select the IP Address field and enter the IP address for the switch.

7. Select the Subnet Mask field and enter the subnet mask for the IP address.

8. Press , then (for S

ave).

For descriptions of these

parameters, see the

online Help for this

screen.

Before using the DHCP/

Bootp option, refer to

“DHCP/Bootp

Operation” on page 7-10.

!Software.book Page 6 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General