To Next Page

To Previous Page

8-18

Time Protocols

TimeP: Viewing, Selecting, and Configuring

For example, suppose:

■ Time synchronization is configured for SNTP.

■ You want to:

1. View the current time synchronization.

2. Select TimeP as the time synchronization mode.

3. Enable TimeP for DHCP mode.

4. View the TimeP configuration.

The commands and output would appear as follows:

Figure 8-12. Example of Enabling TimeP Operation in DHCP Mode

Enabling Timep in Manual Mode. Like DHCP mode, configuring TimeP for

Manual mode enables TimeP. However, for manual operation, you must also

specify the IP address of the TimeP server. (The switch allows only one TimeP

server.) To enable the TimeP protocol:

Syntax: timesync timep Selects Timep.

ip timep manual <ip-addr> Activates TimeP in Manual mode with a

specified TimeP server.

no ip timep Disables TimeP.

Note

To change from one TimeP server to another, you must (1) use the no ip timep

command to disable TimeP mode, and then reconfigure TimeP in Manual

mode with the new server IP address.

show timep displays the TimeP configuration and also shows

that SNTP is the currently active time synchronization mode.

show timep again displays the TimeP configuration and shows

that TimeP is now the currently active time synchronization mode.

➊

➋

➌

➍

!Software.book Page 18 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General