To Next Page

To Previous Page

8-20

Time Protocols

TimeP: Viewing, Selecting, and Configuring

If you then viewed the TimeP configuration, you would see the following:

Figure 8-14. Example of TimeP with Time Sychronization Disabled

Disabling the TimeP Mode. Disabling the TimeP mode means to configure

it as disabled. (Disabling TimeP prevents the switch from using it as the time

synchronization protocol, even if it is the selected

Time Sync Method option.)

Syntax: no ip timep Disables TimeP by changing the TimeP mode

configuration to

Disabled.

For example, if the switch is running TimeP in DHCP mode,

no ip timep changes

the TimeP configuration as shown below, and disables time synchronization

on the switch.

Figure 8-15. Example of Disabling Time Synchronization by Disabling the TimedP

Mode Parameter

Even though the Time Sync Mode is set to Timep,

time synchronization is disabled because no ip

timep has disabled the TimeP Mode parameter.

!Software.book Page 20 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General