HP ProCurve 2650

9-19
Optimizing Traffic Flow with Port Controls, Port Trunking, and Port-Based Priority
Port Trunking
Using a port list specifies, for switch ports in a static trunk group, only the
ports you want to view. In this case, the command specifies ports A5 through
A7. However, because port A6 is not in a static trunk group, it does not appear
in the resulting listing:
Figure 9-8. Example Listing Specific Ports Belonging to Static Trunks
The show trunks [ e ] < port-list > command in the above example includes a
port list, and thus shows trunk group information only for specific ports that
have membership in a static trunk. In figure 9-9-9, the command does not
include a port list, so the switch lists all ports having static trunk membership.
Figure 9-9. Example of a Show Trunk Listing Without Specifying Ports
Port A5 appears with an example of a name that you can optionally assign using the
Friendly Port Names feature. (See “Using Friendly (Optional) Port Names” on page 6-15.)
Port A6 does not appear in this listing because
it is not assigned to a static trunk.
!Software.book Page 19 Thursday, October 10, 2002 6:10 PM