10-6
Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
CLI: Viewing and Configuring Community Names
Listing Community Names and Values. This command lists the data for
currently configured SNMP community names (along with trap receivers and
the setting for authentication traps — see “Trap Receivers and Authentication
Traps” on page 10-8).
Syntax: show snmp-server [<community-string>]
This example lists the data for all communities in a switch; that is, both the
default HPswitch "public" community name and another community named
"blue-team"
Figure 10-3. Example of the SNMP Community Listing with Two Communities
To list the data for only one community, such as the "public" community, use
the above command with the community name included. For example:
HPswitch# show snmp-server public
Community Name Commands Page
show snmp-server [<community-string>] 10-6
[no] snmp-server 10-7
[community <community-str>] 10-7
[host <community-str> <ip-addr>]
[<none | debug | all | not-info | critical>]
10-10
[enabl
e tr
aps <a
uthent
icati
on>
10-11
Default
Community and
Settings
Non-Default
Community and
Settings
Trap Receiver
Data (See page
10-8.)
!Software.book Page 6 Thursday, October 10, 2002 6:10 PM
To Next Page
Loading...
Need help?
General
