To Next Page

To Previous Page

12-7

Multimedia Traffic Control with IP Multicast (IGMP)

CLI: Configuring and Displaying IGMP

Viewing the Current IGMP Configuration. This command lists the IGMP

configuration for all VLANs configured on the switch or for a specific VLAN.

Syntax: show ip igmp config IGMP configuration for all

VLANs on the switch

show ip igmp vlan <vid> config IGMP configuration for a

specific VLAN on the switch,

including per-port data

(For IGMP operating status, see “Internet Group Management Protocol

(IGMP) Status” on page B-19.)

For example, suppose you have the following VLAN and IGMP configurations

on the switch:

You could use the CLI to display this data as follows:

Figure 12-1. Example Listing of IGMP Configuration for All VLANs in the Switch

The following version of the show ip igmp command includes the VLAN ID (vid)

designation, and combines the above data with the IGMP per-port configura-

tion:

VLAN ID VLAN Name IGMP

Enabled

Forward with

High Priority

Querier

1 DEFAULT_VLAN Yes No No

22 VLAN-2 Yes Yes Yes

33 VLAN-3 No No No

!Software.book Page 7 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General