To Next Page

To Previous Page

14-18

HP Procurve Stack Management

Configuring Stack Management

Figure 14-9. Example of the Stack Management Screen

2. Press (for

Add) to add a Candidate. You will then see this screen listing

the available Candidates:

Figure 14-10. Example of Candidate List in Stack Management Screen

3. Either accept the displayed switch number or enter another available

number. (The range is 0 - 15, with 0 reserved for the Commander.)

4. Use the down arrow key to move the cursor to the MAC Address field,

then type the MAC address of the desired Candidate from the Candidate

list in the lower part of the screen.

5. Do one of the following:

For status descriptions, see the table on page 14-46.

The Commander automatically selects an

available switch number (SN). You have the

option of assigning any other available number.

Candidate List

!Software.book Page 18 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General