To Next Page

To Previous Page

14-20

HP Procurve Stack Management

Configuring Stack Management

2. Stacking Status (All)

You will then see the Stacking Status (All) screen:

Figure 14-12. Example of How the Stacking Status (All) Screen Helps You Find

Member MAC Addresses

3. In the Stacking Status (All) screen, find the Member switch that you want

to move and note its MAC address, then press (for

Back) to return to

the Stacking Menu.

4. Display the Commander’s Stack Management screen by selecting

4. Stack Management

(For an example of this screen, see figure 14-9 on page 14-18.)

5. Press (for

Add) to add the Member. You will then see a screen listing

any available candidates. (See figure 14-10 on page 14-18.) Note that you

will not see the switch you want to add because it is a Member of another

stack and not a Candidate.)

6. Either accept the displayed switch number or enter another available

number. (The range is 0 - 15, with 0 reserved for the Commander.)

7. Use the down arrow key to move the cursor to the MAC Address field,

then type the MAC address of the desired Member you want to move from

another stack.

This column lists the MAC

Addresses for switches

discovered (in the local

subnet) that are configured

for Stacking.

Using the MAC addresses for these

Members, you can move them between

stacks in the same subnet.

For status descriptions, see the table on page 14-46.

!Software.book Page 20 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General