To Next Page

To Previous Page

2-6

Using the Menu Interface

Starting and Ending a Menu Session

Figure 2-2. An Asterisk Indicates a Configuration Change Requiring a Reboot

1. In the current session, if you have not made configuration changes that

require a switch reboot to activate, return to the Main Menu and press

(zero) to log out. Then just exit from the terminal program, turn off the

terminal, or quit the Telnet session.

2. If you have made configuration changes that require a switch reboot—

that is, if an asterisk (*) appears next to a configured item or next to Switch

Configuration in the Main Menu:

a. Return to the Main Menu.

b. Press to select Reboot Switch and follow the instructions on the

reboot screen.

Rebooting the switch terminates the menu session, and, if you are using

Telnet, disconnects the Telnet session.

(See “Rebooting To Activate Configuration Changes” on page 2-13.)

3. Exit from the terminal program, turn off the terminal, or close the Telnet

application program.

Asterisk indicates a

configuration change

that requires a reboot

to activate.

!Software.book Page 6 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General