To Next Page

To Previous Page

A-8

File Transfers

Downloading Switch Software

Continue reboot of system? : No

Press the space bar once to change No to Yes, then press to begin

the reboot.

7. To confirm that the switch software downloaded correctly:

a. From the Main Menu, select

1. Status and Counters

1. General System Information

b. Check the Firmware revision line.

CLI: Xmodem Download from a PC or Unix Workstation to

Primary or Secondary Flash

Using Xmodem and a terminal emulator, you can download a switch software

file to either primary or secondary flash.

Syntax: copy xmodem flash [<primary | secondary>]

Note that if you do not specify the flash destination, the Xmodem download

defaults to primary flash.

For example, to download a switch software file named G0103.swi from a PC

(running a terminal emulator program such as HyperTerminal) to primary

flash:

1. Execute the following command in the CLI:

Figure A-4. Example of the Command to Download Switch Software Using Xodem

2. Execute the terminal emulator commands to begin the Xmodem transfer.

For example, using HyperTerminal:

a. Click on Transfer, then Send File.

b. Type the file path and name in the Filename field.

c. In the Protocol field, select Xmodem.

d. Click on the

button.

The download can take several minutes, depending on the baud rate used

in the transfer.

!Software.book Page 8 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General