A-10
File Transfers
Downloading Switch Software
• To download the switch software from the secondary flash of the
source switch, type /os/secondary.
5. Press , then (for eX
ecute) to begin the switch software download.
6. A “progress” bar indicates the progress of the download. When the entire
operating system has been received, all activity on the switch halts and
the following messages appear:
Validating and writing system software to FLASH...
7. After the primary flash memory has been updated with the new operating
system, you must reboot the switch to implement the newly downloaded
software. From the Main Menu, press (for Reboot Switch). You will then
see this prompt:
Continue reboot of system? : No
Press the space bar once to change No to Yes, then press to begin
the reboot.
8. To confirm that the operating system downloaded correctly:
a. From the Main Menu, select
Status and Counters
General System Information
b. Check the Firmware revision line.
CLI: Switch-To-Switch Downloads
You can download a switch software file between two Switches 2650 and 6108
connected on your LAN by initiating a copy tftp command from the destination
switch.The options for this CLI feature include:
■ Copy from primary flash in the source to either primary or secondary in
the destination.
■ Copy from either primary or secondary flash in the source to either
primary or secondary flash in the destination.
Downloading from Primary Only. This command (executed in the destina-
tion switch) downloads the switch software from the source switch’s primary
flash to either the primary or secondary flash in the destination switch.
Syntax: copy tftp flash <ip-addr> flash [primary | secondary]
If you do not specify either a primary or secondary flash location for the
destination, the download automatically goes to primary flash.
!Software.book Page 10 Thursday, October 10, 2002 6:10 PM
To Next Page
Loading...
Need help?
General
