To Next Page

To Previous Page

A-15

File Transfers

Transferring Switch Configurations

Xmodem: Copying a Configuration File from a Serially Connected PC

or Unix Workstation. To use this method, the switch must be connected via

the serial port to a PC or Unix workstation on which is stored the configuration

file you want to copy. To complete the copying, you will need to know the

name of the file to copy and the drive and directory location of the file.

Syntax: copy xmodem startup-config <pc | unix>

For example, to copy a configuration file from a PC serially connected to the

switch:

1. Execute the following command:

2. After you see the above prompt, press .

3. Execute the terminal emulator commands to begin the file transfer.

4. When the download finishes, you must reboot the switch to implement

the newly dowloaded OS. To do so, use one of the following commands:

boot system flash <primary | secondary>Reboots from the selected

flash.

-or-

reload Reboots from the flash image

currently in use.

(For more on these commands, see “Rebooting the Switch” on page 5-17.)

!Software.book Page 15 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General