3-14
Using the Command Line Interface (CLI)
Using the CLI
Figure 3-9. Context-Specific Commands Affecting Port Context
HPswitch(eth-C5-C8)#?
HPswitch(eth-C5-C8)#?
Lists the commands you
can use in the port or static
trunk context, plus the
Manager, Operator, and
context commands you
can execute at this level.
In the port context, the first block of commands in the "?"
listing show the context-specific commands that will affect
only ports C3-C6.
The remaining commands in the listing are Manager,
Operator, and context commands.
!Software.book Page 14 Thursday, October 10, 2002 6:10 PM
To Next Page
Loading...
