To Next Page

To Previous Page

4-10

Using the HP Web Browser Interface

Tasks for Your First HP Web Browser Interface Session

Note Passwords you assign in the web browser interface will overwrite previous

passwords assigned in either the web browser interface, the Command

Prompt, or the switch console. That is, the most recently assigned passwords

are the switch’s passwords, regardless of which interface was used to assign

the string.

Using the Passwords

Figure 4-4. Example of the Password Window in the Web Browser Interface

The manager and operator passwords are used to control access to all switch

interfaces. Once set, you will be prompted to supply the password every time

you try to access the switch through any of its interfaces. The password you

enter determines the capability you have during that session:

■ Entering the manager password gives you full read/write capabilities

■ Entering the operator password gives you read and limited write capabil-

ities.

Using the User Names

If you also set user names in the web browser interface screen, you must

supply the correct user name for web browser interface access. If a user name

has not been set, then leave the User Name field in the password window

blank.

Note that the Command Prompt and switch console interfaces use only the

password, and do not prompt you for the User Name.

!Software.book Page 10 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General