To Next Page

To Previous Page

4-24

Using the HP Web Browser Interface

Status Reporting Features

■ High Sensitivity. This policy directs the switch to send all alerts to the

Alert Log. This setting is most effective on networks that have none or

few problems.

■ Medium Sensitivity. This policy directs the switch to send alerts related

to network problems to the Alert Log. If you want to be notified of

problems which cause a noticeable slowdown on the network, use this

setting.

■ Low Sensitivity. This policy directs the switch to send only the most

severe alerts to the Alert Log. This policy is most effective on a network

that normally has a lot of problems and you want to be informed of only

the most severe ones.

■ Never. Disables the Alert Log and transmission of alerts (traps) to the

management server (in cases where a network management tool such as

HP TopTools for Hubs & Switches is in use). Use this option when you

don’t want to use the Alert Log.

The Fault Detection Window also contains three Change Control Buttons:

■ Apply Changes. This button stores the settings you have selected for all

future sessions with the web browser interface until you decide to change

them.

■ Clear Changes. This button removes your settings and returns the

settings for the list box to the level it was at in the last saved detection-

setting session.

■ Reset to Default Settings. This button reverts the policy setting to

Medium Sensitivity for Log Network Problems.

!Software.book Page 24 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General