HPE FlexFabric 5950 Series

155
Syntax
ip load-sharing mode per-flow [ algorithm algorithm-number | [ dest-ip | dest-port | ip-pro |
src-ip | src-port | ingress-port ] * | tunnel { inner | outer } ] { global | slot slot-number }
undo ip load-sharing mode { global | slot slot-number }
Default
The device performs per-flow load sharing based on the following criteria: source IP address,
destination IP address, source port number, destination port number, IP protocol number, ingress
port, and VLAN.
Views
System view
Predefined user roles
network-admin
Parameters
per-flow: Implements per-flow load sharing.
dest-ip: Identifies flows by destination IP address.
dest-port: Identifies flows by destination port.
ip-pro: Identifies flows by protocol number.
src-ip: Identifies flows by source IP address.
src-port: Identifies flows by source port.
ingress-port: Identifies flows by ingress port.
algorithm algorithm-number: Specifies an algorithm for per-flow load sharing. The value range for
the algorithm-number argument is 0 to 13, and the default value is 0.
tunnel: Performs load sharing for IP tunnel packets.
inner: Identifies flows by inner IP header information.
outer: Identifies flows by outer IP header information.
global: Configures the load sharing mode globally.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command configures the load sharing mode for all member devices.
Examples
# Configure per-flow load sharing for slot 1.
<Sysname> system-view
[Sysname] ip load-sharing mode per-flow slot 1