EasyManua.ls Logo

HPE FlexFabric 5950 Series

HPE FlexFabric 5950 Series
363 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
203
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives: 0
InTooShorts: 0
InTruncatedPkts: 0
InHopLimitExceeds: 0
InBadHeaders: 0
InBadOptions: 0
ReasmReqds: 0
ReasmOKs: 0
InFragDrops: 0
InFragTimeouts: 0
OutFragFails: 0
InUnknownProtos: 0
InDelivers: 0
OutRequests: 0
OutForwDatagrams: 0
InNoRoutes: 0
InTooBigErrors: 0
OutFragOKs: 0
OutFragCreates: 0
InMcastPkts: 0
InMcastNotMembers: 0
OutMcastPkts: 0
InAddrErrors: 0
InDiscards: 0
OutDiscards: 0
Table 44 Command output
Field Description
Vlan-interface2 current state
Physical state of the interface:
• Administratively DOWN—The interface has been administratively
shut down by using the shutdown command.
• DOWN—The interface is administratively up but its physical state is
down, possibly because of a connection or link failure.
• UP—The administrative and physical states of the interface are
both up.
Line protocol current state
Link layer state of the interface:
• DOWN—The link layer protocol state of the interface is down.
• UP—The link layer protocol state of the interface is up.
IPv6 is enabled
IPv6 is enabled on the interface. This feature is automatically enabled
after an IPv6 address is configured for an interface.
link-local address Link-local address of the interface.
Global unicast address(es)
Global unicast addresses of the interface.
IPv6 address states:
• TENTATIVE—Initial state. DAD is being performed or is to be
performed on the address.

Table of Contents

Other manuals for HPE FlexFabric 5950 Series

Related product manuals