HPE FlexNetwork 5130 HI SERIES

346
Table 85 Default output rules
Destinatio
n
Source
module
s
Common log Security log Diagnostic log Hidden log
Console
All
supported
modules
debugging Disabled Disabled Disabled
Monitor
terminal
All
supported
modules
debugging Disabled Disabled Disabled
Log host
All
supported
modules
informational Disabled Disabled informational
Log buffer
All
supported
modules
informational Disabled Disabled informational
Log file
All
supported
modules
informational Disabled Disabled informational
Security log
file
All
supported
modules,
cannot be
filtered
Disabled
Debugging,
which cannot be
filtered
Disabled Disabled
Diagnostic
log file
All
supported
modules,
cannot be
filtered
Disabled Disabled
Debugging, which
cannot be filtered
Disabled
Views
System view
Predefined user roles
network-admin
Parameters
module-name: Specifies a module by its name. You can use the info-center source ? command to
view the modules supported by the device.
default: Specifies all supported modules.
console: Outputs logs to the console.
logbuffer: Outputs logs to the log buffer.
logfile: Outputs logs to the log file.
loghost: Outputs logs to the log host.
monitor: Outputs logs to the monitor terminal.
deny: Disables log output.
level severity: Specifies a severity level in the range of 0 to 7. The smaller the severity value, the
higher the severity level. See Table 80 for more information. Logs
at the specifi
ed severity level and
higher levels are allowed or denied to be output.