Huawei OceanStor S2600 - Command of Querying the Information about a Host Port Module; Showinterface

Usage Guidelines
The command showcomsleep -t component type is used to query whether all components are
allowed to hibernate. If allowed, query whether the components are in hibernation state and the
wait time before hibernation.
The command showcomsleep -i raid id -t component type is used to query whether specified
component is allowed to hibernate. If allowed, query whether the components are in hibernation
state and the wait time before hibernation.
Example
Query whether the components are allowed to hibernate, If allowed, query whether the
components are in the hibernation state and the wait time before hibernation.
OceanStor: admin> showcomsleep -i 0 -t 1
RAID Id Is Allow Hibernate Hibernate Status Idle Time
0 Yes sleep ten minutes
5.5 Command of Querying the Information About a Host
Port Module
Command of querying the information about a host port module is used to query the information
about the host port module.
5.5.1 showinterface
5.5.1 showinterface
Function
The command showinterface is used to query the information about an host port module.
Format
showinterface [ -c controller ID [ -i interface ID ] ]
Parameters
Keyword and Value
Description Default Value
-c controller ID The controller ID. The value
is A or B, and is case
insensitive.
None.
-i interface ID The ID of an host port
module.
0.
OceanStor S2600 Storage System
Command Reference 5 Device Management Commands
Issue 07 (2010-05-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-13