This operation will lead to interrupt the service!
Do you want to continue? y or n: y
5.13.6 chgiscsiroute
Function
The command chgiscsiroute is used to set the routing information about an iSCSI host port.
Format
chgiscsiroute [ -d ] -c controller ID -p Port ID -a Dest IP address -s subnet mask -g gateway
Parameters
Keyword and Value Description Default Value
-d Delete the routing settings of
a specified iSCSI host port.
None.
-c controller ID The controller ID. The value
is A or B, and is case
insensitive.
None.
-p Port ID The ID of the iSCSI host port
on the controller. The value
ranges from 0 to 3.
l S2600i: Each host port
module is configured with
four iSCSI host ports.
From left to right, the host
ports are numbered 0, 1, 2,
and 3 in sequence.
l S2600C: Each host port
module is configured with
two FC host ports and two
iSCSI host ports. From left
to right, the iSCSI host
ports are numbered 0 and
1 in sequence.
None.
-a Dest IP address The network segment which
the destination host belongs
to.
None.
-s subnet mask The subnet mask of the
destination host.
None.
-g gateway The gateway of the iSCSI
host port on the controller.
None.
OceanStor S2600 Storage System
Command Reference 5 Device Management Commands
Issue 07 (2010-05-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-31
To Next Page
Loading...
