Huawei OceanStor S2600 - Chgiscsiip

Modes
Normal mode.
Level
Super administrator level, administrator level and guest level.
Usage Guidelines
When using this command, note the following items:
l The command showiscsiip is used to query the IP addresses of all iSCSI host ports.
l The command showiscsiip -c controller ID -p port ID is used to query the IP address of a
specified iSCSI host port on a controller.
NOTE
The command is only applicable to iSCSI host ports on the controller of the storage device.
Example
Query the IP addresses of all iSCSI host ports.
OceanStor: admin> showiscsiip
Controller Port ID IP Address Subnet Mask
A 0 192.168.1.153 255.255.255.0
B 0 192.168.26.1 255.255.255.0
5.13.5 chgiscsiip
Function
The command chgiscsiip is used to change the IP addresses of iSCSI host ports.
Format
chgiscsiip -c controller ID -p Port ID -a IP address -s subnet mask -m config mode
Parameters
Keyword and Value
Description Default Value
-c controller ID The controller ID. The value
is A or B, and is case
insensitive.
None.
OceanStor S2600 Storage System
Command Reference 5 Device Management Commands
Issue 07 (2010-05-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-29